![dsc alarm panel shows open dsc alarm panel shows open](https://i.ytimg.com/vi/3NGp657qmf0/hqdefault.jpg)
Go to the Advanced tab, and set three variables, all with the service ID "urn:micasaverde-com:serviceId:AlarmPanel1": Note the number of each one (partitions are numbered 1-8, zones are 1-64) and open the main panel device.
![dsc alarm panel shows open dsc alarm panel shows open](https://www.alarmmaintenance.com.au/dsckey3.jpg)
(this is a confirmation for you to know that Vera is communicating with the DSC)Ħ) Partitions and zones are configured on the panel itself. Go to the Settings tab and under Send using: option select the port used to communicate with the IT-100 interface.ģ) On the DSC Alarm Panel tab, under the Access Code option type your access code (4 to 6 digits)Ĥ) Close the pop up window and press the Save buttonĥ) Go back to the DSC Alarm Panel tab and above the Access Code option you should see the time.
Dsc alarm panel shows open serial#
You have to associate the serial port with the main panel device. You should rename this device so you can identify it easily in the future.Ģ) If the IT-100 interface is connected to Vera with an USB-Serial adapter, there should appear a serial port device. Press the little wrench key in the upper right corner of the newly created device and access the control window. Also in the Devices sections you will find a new device created. You will see the plugin installed in the MiOS Marketplace section.
Dsc alarm panel shows open install#
Search for the DSC Alarm Panel plugin and install it.
![dsc alarm panel shows open dsc alarm panel shows open](https://securitycamcenter.com/wp-content/uploads/2021/05/ADT-yellow-triangle.jpg)
Press this button and it will open the Marketplace window (On newer firmware versions, above it will open a new tab on your browser and you will have to log in with the cp. credentials to install plugins). There's no functional difference between them, but a UI can list them apart, or show different icons.īefore starting working on Vera the DSC Alarm device should already be configured with Partitions, Zones and Sensors.ġ) On the dashboard go to the MiOS Marketplace section and in the upper right corner of this section you will find a green plus ( + ) sign. Currently you can select which appears as 'Smoke sensors' and which as 'Motion sensors'. On the main tab the device shows the partition status ('Ready', 'In Alarm', 'Disarmed', etc), and has five buttons to send commands to the partition: 'Away', 'Stay', 'Armed no Entry Delay', 'Arm with Code', 'Disarm'.Įach zone is represented as a sensor device.